1305-03047 PowerPRO Cat.5e ezi-JACK Vertical Jack

Order Now

If its terminating speed that you’re after, then look no further than the DINTEK PowerPRO™ ezi-JACK. These Jacks provide performance that exceeds category 5E connecting hardware performance specifications.

The DINTEK ezi-TOOL system is an all-in-one punch down and wire trim process, design to assure consistent connections, better performance and faster fit off times. 

The PowerPROTM 90 degree ezi-JACK works with either the  ezi-TOOL or a standard 110 style DINTEK punch down tool.


  • Voice; T1; ISDN
  • 10BASE-T (IEEE 802.3)
  • 16Mbps Token Ring (IEEE802.5) 
  • 100VG-AnyLAN (IEEE802.12)
  • 100BASE-T Ethernet (IEEE802.3)
  • 155/622Mbps 1.2/2.4 Gbps ATM
  • 1000Mbps Gigabit Ethernet
  • 550MHz Broadband Video


  • UL, ETL Verifi ed
  • ANSI/TIA-568-C.2
  • ISO/IEC 11801
  • EN 50173


  • Meet all category 5e channel performance requirements specified in ANSI/TIA-568-2.D
  • 110 type IDC termination
  • Accept 22~26AWG, stranded or solid wire
  • Modular jack meet FCC part 68
  • Wiring: T568A/B

Ordering Information
Product NumberProduct NameOrientation


Std Pkg Qty


Cat.5e 180 degree unshielded F-Jack,T568A/B



1pcs/PE bag

Technical Specifications
Connector HousingHigh Impact Flame-Retardant Plastic
StandardUL94v-0 rated
Front Connection
Contact TypeSpring Wire
MaterialPhosphor Bronze Alloy Plated with 50 micro-inch of Gold over 70~100 micro-inch of Nickel

Contact Plating

24 Karat hard gold (50 micro-inch plating thickness) over 100 micro-inch nickel

Rear Terminals
Terminal TypeIDC
MaterialPhosphor Bronze Alloy with 10 micro-inch 100% Sn Alloy
Physical Ranges
Temperature Range
Stroage-40 to +70℃
Operational-10 to +60℃
Relative humidity
OperationalMax. non-condensing 93%
Retention50N (11 Ibf) for 60s ± 5s
Insertion/Extraction life750 cycles minimum
Number of IDC terminations200 minimum

Total mating force

800 grams for a 8 wire leads minimum

Insulation Resistance500 mΩ min.@ 100V d.c
Dielectric Withstanding Voltage1000 V d.c. or a.c. Peak Contact to Contact @ 60 Hz for 1 MIN.
Spring Wire Contact Resistance20 mΩ Max.
Voltage/Current Rating150VAC/1.5A
IDC Contact Resistance2.5 mΩ Max.

Termination Demonstration

Vertical ezi-JACK 

Strip 40mm of sheath from cable using stripper

Using working base, place wires as per color spec

Make sure that twists are right up to termination points

Insert jack into ezi-TOOL with Yellow cutting blade

Squeeze handles together terminating and trimming wires

Check terminations, then place dust cap onto jack


Get A Quote